Injector: Difference between revisions

Latest revision as of 00:39, 18 March 2025

Injector is a device found on steam engines , used to feed water to the boiler from storage , in order to maintain nominal water level . It is usually operated by a valve, and can be opened or closed.

Stored water is cold. As it is injected into the boiler, it may drop temperature of the water already there, causing steam to condense back into water. This can result in significant pressure drop, so water injection is recommended to be done at small amounts and well timed .

There is no way to monitor water temperature, other than indirectly by looking at the speed the boiler pressure gauge needle is moving.

Injectors normally rely on steam pressure to inject water, but in Derail Valley this limitation is omitted to avoid complications when starting a cold engine.

@@ Line 2: / Line 2: @@
 <translate>
 <!--T:1-->
-To transfer water from the {{pll|Water Storage|tank}} to the {{pll|Boiler|boiler}} {{pll|Steam Overview|steam engines}} use a device called the injector. It’s usually operated by a large valve handle that is twisted to be opened or closed. Injectors use steam pressure to inject water from one vessel to the other.
+Injector is a device found on {{pll|Steam Overview|steam engines}}, used to feed water to the {{pll|Boiler|boiler}} from {{pll|Water Storage|storage}}, in order to maintain nominal {{pll|Water Level|water level}}. It is usually operated by a valve, and can be opened or closed.
 <!--T:2-->
-As cold water is being added from a {{pll|Rail Vehicle Types|tender}}, it will affect the temperature of the water already in the boiler. Hence, it is recommended to {{pll|Driving Efficiency|add water slowly and continuously}}, proportional to the consumption and needs, to not disrupt steam creation too much. There is no way to monitor water temperature, other than indirectly by looking at the speed the pressure gauge needle is moving.
+Stored water is cold. As it is injected into the boiler, it may drop temperature of the water already there, causing steam to condense back into water. This can result in significant pressure drop, so water injection is recommended to be done at small amounts and {{pll|Driving Efficiency|well timed}}.
+<!--T:3-->
+There is no way to monitor water temperature, other than indirectly by looking at the speed the boiler pressure gauge needle is moving.
+<!--T:4-->
+Injectors normally rely on steam pressure to inject water, but in Derail Valley this limitation is omitted to avoid complications when starting a cold engine.
 </translate>
-{{See also|Steam Overview|Fire Management|Service Point|Mechanical Powertrain Damage}}
 [[Category:Water Management|3]]