Jump to content

Hladina vody

From Derail Valley
Revision as of 14:02, 12 March 2025 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

When running steam engines , the most critical responsibility is to maintain a nominal level of water in the boiler . This is done by observing a water gauge and adjusting the water level accordingly. The water level should always be visible within the water gauge, typically ranging between 75% and 85% of the boiler height.

If water rises above the limit, there are two potential dangers - there is less room for steam to be generated in, and water can overflow into the cylinders , potentially causing them to break .

If water falls under the limit, the boiler can explode and cause catastrophic damage . If the firebox is sufficiently hot and its top surface, known as “crown sheet”, protrudes above the water level, it can soften from high temperatures and pressure, and lead to the boiler explosion.

In an emergency attempt to save the engine from explosion, immediately feed water and dump coal from the firebox.

Water is fed to the boiler from storage using an injector . It is dumped from the boiler using a blowdown valve, usually found in a vehicle's cab .

Hladina vody je také závislá na sklonu. Pokud jede lokomotiva z kopce, hladina se bude jevit nižší než na rovině a naopak. V případě nouze je jedním ze způsobů, jak zabránit výbuchu, vypouštění páry z kotle odkalovacím ventilem, dmychavkou nebo dokonce odvodňovacími ventily.

Water level is also grade dependent, and subject to sloshing. If the vehicle is going downhill, the level will appear lower than on a flat surface, and vice versa.